Century SMART MOVE PM-1634AB 6/01 Manuel d'utilisateur

InstructionManualAvoid injury or death -Read and understand this manual!Para instrucciones en Español,llamar al: 1-800-837-4044www.centuryproducts.co

Adjust car seat to upright or semi-upright position and place forward-facing on vehicle seat.Thread vehicle seat belt through openings andbehind harne

(fig. a) (fig. b)(fig. c)(fig. d)(B)(A)Pull totighten9FORWARD-FACING INSTALLATION (continued)Openings

Place child in car seat with child’s back flat against back of car seat.Place harness straps over child’s shoulders and insert tongues into buckle.Pul

1123(fig. a) (fig. b)PLACING CHILD IN CAR SEAT (continued)4

OPERATIONS and ADJUSTMENTSRecline / Upright Positions:Rear-facing - MUST use Reclined (#1) or Semi-reclined (#2) position.Forward-facing - MUST use S

13(fig. a)(fig. b)123UpperLower(fig. c)4OPERATIONS and ADJUSTMENTS (continued)

14Changing Harness Strap Slots:A Loosen harness straps:Pull and hold upper belt tab.Pull harness straps out.B Remove both harness strap loops from Spl

15BottomLoopSplitter PlateTopLoopOPERATIONS and ADJUSTMENTS (continued)(fig. f)Rear Recline Lever(fig. e)

16VEHICLE SEAT BELTSTo provide the most secure installation of the car seat:• Read the vehicle owner’s manual regardingcar seat installation and seat

17Vehicle seat belts located forward of seat crease may not securely hold car seat. Check vehicle owner’s manual or see vehicle dealer forcar seat in

TABLE OF CONTENTSImportant Information...1Warnings...2Basic In

18Lap belts with retractors may or may not hold a car seat securely.Follow these steps to determine if you have a retractor system that will hold car

19DO NOT use with any car seat.❃Passive Restraint - Lap Belt with Motorized Shoulder BeltDO NOT use with any car seat. Belts will not stay tight whil

20Pull on latch plate (fig. a). If belt slides freelythrough latch plate, a locking clip MUSTbe used (see Locking Clip section).Some combination lap/

211/2 inch (1 cm)(fig. a)VEHICLE SEAT BELTS (continued)Avoid serious injury or death:• Failure to use locking clip whererequired will result in car se

ADDITIONAL INFORMATION 22Vehicle may already be equipped with a tether anchor (top strap anchor). See vehicle owner’s manual for location.If vehicle

23ADDITIONAL INFORMATION (continued)DO NOT anchor tether strap to the vehicle when using car seat rear-facing. Tether hook must be attached to car sea

Removing Seat Pad:Remove both harness strap loops from Splitter Plate on back of car seat.Pull harness straps out of harness slots.Remove from harness

25ADDITIONAL INFORMATION (continued)Seat Pad:Machine-wash separately on gentle cycle anddrip dry.Harness Straps:Surface wash only with mild soap and d

Store instruction manualbehind these tabs.Store Locking Clipon bottom of car seat.Fold instruction manual.1If a part is damaged, missing, or you need

IMPORTANT INFORMATIONNo car seat can guarantee protection from injury in every situation, but proper use helps reduce the risk of serious injury or de

WARNINGS - Prevent serious injury or death:DO NOT use rear-facing childrestraint in a vehicle seating position equipped with an air bag.Child’s head a

3DO NOT use car seat if it is damagedor has missing parts. DO NOT use accessories or partsother than those provided byCentury or Graco. Their use co

BASIC INFORMATIONThis car seat meets or exceeds all applicable requirements of Federal Motor Vehicle Safety Standard 213 for use in motor vehicles and

Forward-facingHEIGHT & WEIGHT LIMITSA preterm infant or low birth weight infant may be at special risk in a vehicle or aircraft.According to the A

When using car seat rear-facing, car seat MUSTbe able to rotate freely from a reclined to an upright position on impact.• Test by moving car seat thro

(fig. b)(fig. d)(fig. e)OpeningsTowelsREAR-FACING INSTALLATION (continued)7(fig. c)(fig. a)